Foot Measurement Guide
Find Your Boot Size
Accurate foot measurement guide for Carpenter Boot Company boots
How To Measure Your Feet
- On a hard surface, tape a piece of blank paper to the floor and attach it flush against the wall.
- Stand on the paper with your heel against the wall. Place approximately 80% of your body weight on your foot with a slightly bent knee.
- Mark the longest part of your foot (heel-to-toe) and the widest part of your foot with a pen held perfectly vertical. Repeat with the other foot.
- Use a ruler to measure both length and width in millimeters (mm). If you donβt have a metric ruler, you can print one below.
- Enter your measurements into our boot sizer (or contact us) to find your CBC size.
- Note: Our boot sizing is based on skating barefoot. If you plan to wear socks, consider going one size up for comfort.
Watch Measurement Guide
CBC Boot & Blade Recommender
Short Track
Long Track
Note: These are general guidelines based on Carpenter Boot Company official charts.
All blades come pre-bent but NOT rockered β professional rockering is required.
Boots are built on the worldβs best-fitting last and usually do not require heat molding.
All blades come pre-bent but NOT rockered β professional rockering is required.
Boots are built on the worldβs best-fitting last and usually do not require heat molding.